Open Ended Lab: Designing a Signal Generator with 8 different outputs

Oscillator Circuits

Active Filters in Orcad PSpice

AutoCAD Flat Design Full

Applications of Op-Amp: Slew Rate & Gain-Bandwidth Product

Floor Design Essentials (Part 1)

Basic Applications of Op-Amp

MOS Amplifier & BJT CE Amplifier

AutoCAD Basics

CE & CB Config of BJT & building OR & AND gate using CMOS PMOS

Diode Analysis (Clipper,Clamper & Zener Diode)

Introduction of SemiConductor devices in PSpice

Assignment on building a 8-bit shift register with corresponding roll number

Introduction to Sequencial Logic Circuits

Introduction to Encoders and Decoders.

Introduction to Multiplexers and Demultiplexer

Introduction Binary adder and BCD adder circuit (4 bit)

Introduction to Adder Circuit.

Introduction to FPGA, Quartus Software & Verilog HDL

Proteus Installation process and Exp-02 (Introduction to Combinational Logic and K-map Minimization)

AC Power measuring using wattmeter

Studying Resonance behaviour of a parrallel R-L-C circuit

Familiarization with AC current waveshapes

Study of Resonance behaviour of a series R-L-C circuit with variable capacitance

Determination of bandwidth and quality factor of a series R-L-C circuit

Equivalent resistance measure using Tinkercad by Ohmmeter,Potentiometer, Voc/Isc, and Vs/Is method

Verification of Thevenin’s Theorem and Maximum Power Transfer Theorem Lab Experiment using TinkerCad

Verification of superposition theorem using simulation in LTSpice.

Equivalent resistance measure using LTSpice by Potentiometer method, Voc/Isc method and Vs/Is method