I am new to the hobby and was having trouble with INAV and Speedybee Fc to flash I must have watched 30 or 40 videos with no results UNTIL I found your videos and you covered one aspect of the process that no one else did I thank you for the time you take on you videos Thank you Eugene M
1 month ago
| 0
I bought a bag of 6 wire plugs like that . They can be cut into 5 wire , 4 wire ,3 wire plugs with sharp wire cutter and mabe clean with a razor only if it needs it . Great for hooking up hd and gps andother stuff onto flight controllers with plugs . Then you can use the same expensive hd vtx or rx or gps on multiple models without desoldering and resoldering .
1 month ago | 0
It's SH 1.0. all DJI and WS cables and most FC plugs are SH 1.0. Analog cameras use PB 1.25 aka MX 1.25. 1st gen DJI AUs use GH 1.25 and things like air speed sensors use GH 1.25 also. The odd ball is the Heewing PDBs on the T2 Cruza. They use ZH 1.5. and of course the standard Wing FC pins are Dupont 2.54. How do I know all of this? I have 11 or 12 different kits converting one type of connector to another ie: "PB 1.25 to Dupont 2.54 Female" and I've had to figure all this out over many quad/plane builds.
1 month ago
| 3
BTW if you are looking to buy these kits off of Amazon, they were around $23 each when I bought mine. (2023-2024) No idea if they are more now. You want to type "SH 1.0 Silicone wire" or "PB 1.25 to SH 1.0 Silicone wire" and make sure the listing states that the kit comes with SILICONE wire or you will get one with crap plastic coated wire. The brand "ELECHAWK" has always been my go to kit.
1 month ago | 0
Painless360
I had a few questions on the cable for the DarwinFPV DJI 04 Air Unit Waterproof case cable. Here is a closeup.
It looks identical to the existing connectors used on the 04 (and Walksnail AVATAR) units...
1 month ago | [YT] | 25