I've had the same issue mpu failure..Don't feed 3.3v from mpu 6050 to NRF24L01 use a dedicated 3.3v regulator to NRF24L01..
2 months ago | 2
You are keeping it real for the drone community, thanks man
2 months ago
| 1
Been following this project for a while and slowly gathering every component, The main problem is pcb fabrication in India has become very costly! So Had to design my 2layer pcb on Easyeda! And don’t have hot air station so had to keep the components solderable with iron. I want to share my project with you and want some suggestions for that.
2 months ago | 1
i started learning arduino and i burnt my arduino uno 2 day ago 😅
2 months ago | 1
Max Imagination
[ETT-24] MPU6050 Not Working? 5 Mistakes Killing Your Drone's Sensor
If you want to learn ESP32/Arduino/Electronics, gain expert insights, and access 1000s of projects from around the world, read Elektor Magazine (Get 50% OFF a 1-year Elektor Green Subscription): www.elektormagazine.com/maximagination-elektor-off…
In this Electronics Tip Tuesday, learn how to correctly run an MPU6050 Gyro + Accelerometer sensor for your DIY drone, avoiding the common mistakes.
The MPU6050 was used in the mini Arduino FPV Drone, ESP-FLY drone, and FPV head-tracking camera projects to track tilt and orientation.
#electronicstiptuesday #electronicsprojects #mpu6050 #electronicsengineering #microcontrollers #esp32 #arduino #imu #drones
2 months ago | [YT] | 402