I would probs change the motor triac on main board.. but if looks fine. Check for any solder bridges between pins.. could be fault from factory. Check the drum for any leaks that could be dripping onto motor
4 months ago | 0
got one that shows e22 (pump error) but it drains fine, it doesn't show the error on rapid 14/30/44 turns out the positive from the heater was disconnected, hope it works
4 months ago
| 3
WasherTech
Latest machine that I got today. Paid £25 for it, it’s broken and only a year old!! It’s a candy smart CS1482DE/1-80. So the issue with it is that it shows E01. Long story short then whenever I started the machine it would show the error and then lock and then I played around with the cycles and then it locked and showed E01. So I ended up changing door lock but did nothing, looked at the board and looked fine so thought I would change ntc as I know these can be a bit funny with how they show their errors. It errored once but then didn’t error when I put it on spin only no spin and went through to end so I started to think hmm motor issue? But then I put it on a spin and it worked. Then I left it for half an hour and the error came back but after fighting with it to go again it started again.. And then I left it for ANOTHER HALF HOUR and it appears to be ok so think it’s just very temperamental? The dates on the inside say it was made around feb march or April of 2023
4 months ago | [YT] | 74