Just finished mine. Man those little LED's can tangle!!. I was tearing my hair out before I had a eureka moment. Used a used 3d printer filament spool to wind them round and put them on from there. WLED looks awesome. Especially like fireworks 1D.
3 years ago (edited)
| 0
Have been looking at doing this, will need to do it for next xmas given shipping times but looking for recommendations on LED's for this if anyone has any?
3 years ago (edited) | 0
If I have a controller with a 3 splitter coming out . can I splice all into 1 to make more power to run 1 100 foot light strip ? My lights are only 1/2 lighting up off 1 channel .
1 year ago | 0
I'm designing custom LED decorations , my problem is having the playlist ( programmed segments, ) start when it is plugged back in... ( i just want to use the WIFI and WLED APP when programming , then forget about it ) any help here?
1 year ago | 0
Hey QuinLed! I've gone full in on QuinLED for an upcoming project and am hoping to get some advice. I tried posting to Reddit without much luck, and hoping to get some advice here. Can I use DDP/RGB to map these LEDs to a main controller that will receive an SACN signal and have that Main controller send out the stream to the assigned LEDs via DDP/RGB? I want to "main controller" to act upon virtual LEDs only. Is this sort of thing possible? I finally have 6 controller units set up to test with, but was hoping to verify that it is even possible for one unit toe receive a SACN stream and to them propagate the control out to secondary controllers with physical LEDs attached.
1 year ago | 0
I'm designing custom LED decorations , my problem is having the playlist ( programmed segments, ) start when it is plugged back in... ( i just want to use the WIFI and WLED APP when programming , then forget about it ) any help here?
1 year ago | 0
I'm designing custom LED decorations , my problem is having the playlist ( programmed segments, ) start when it is plugged back in... ( i just want to use the WIFI and WLED APP when programming , then forget about it ) any help here?
1 year ago | 0
Intermit.Tech
If you where looking at creating an addressable LED "WLED" Christmas tree, there is still time! I have a full guide available on how I build mine over here: quinled.info/2020/11/29/diy-addressable-christmas-…
Boards are fully in stock at WorldWide and a huge shipment is currently in the air to DrZZS so available there soon!
3 years ago | [YT] | 67