We're putting a Barra in WHAT?! || KingBarra Part 1

A better look at the HQ || Baseline Runs || Build Plan || KingBarra Part 2

186 Out || Dummy Barra || KingBarra Part 3

Uh Oh! || Not Enough Room || KingBarra Part 4

We Cut Up a HQ to fit a BARRA! || KingBarra Part 5

Engine Mounts and New Gearbox Crossmember! || KingBarra Part 6

Cramped Front End + Rear End Issues || KingBarra Part 7

Column Shift Race Car?? || KingBarra Part 8

Off to Fab (for now) || KingBarra Part 9

Salon || Back Early || New Parts || More Problems || KingBarra Part 10

HQ Take's 9-Inch in Rear End || KingBarra Part 11

Vintage Air A/C System || Oil + Trans Cooler || Cutting Up the Bonnett || KingBarra Part 12

Lots of Little Things || KingBarra Part 13

Wiring and Fabrication || KingBarra Part 14

Just a General Update || HQ?? || Dyno || Shed

Bits and Bobs || KingBarra Part 15

Transforming HQ Firewall + Some more smaller progress || KingBarra Part 16

Green Top Barra Rebuild || KingBarra Part 17

Fitting the Barra + T400 into the HQ! || KingBarra Part 18

Removing Barra Again!? + Lots of Part Prototyping Process || KingBarra Part 19

Slowly shortening the list || KingBarra Part 20

Finally starting to take shape! || KingBarra Part 21

So Close! But So Far.. || KingBarra Part 22

Custom 3D Printed HQ Grill! || KingBarra Part 23

Complete Engine Bay First Look || KingBarra Part 24

ITS ALIVE || KingBarra Part 25

IC7 Solution | Brakes | Pinion Angle || KingBarra Part 26

Dyno Run-In || KingBarra Part 27

Power Runs! (NOT GOOD) || KingBarra Part 28

Rebuilding KingBarra in 3 Days?! || KingBarra Part 29